MITSUBISHI
Home >> Products >> MITSUBISHI >> R series PLC >> CPU module >> NZ2MC-2MBS Extended SRAM card

NZ2MC-2MBS Extended SRAM card

MITSUBISHI NZ2MC-2MBS Manual And Instructions
NZ2MC-2MBS datasheetPDF datasheet

MITSUBISHI NZ2MC-2MBS Product information and technical parameters:
Brand: MITSUBISHI
Name: Extended SRAM card
Model: NZ2MC-2MBS
Capacity: 2MB.

Output points: 16 points.
Output form: Transistor (source) output.
Rated open and close voltage, current: -.
Rated load voltage: DC12 ~ 24V.
Max load current: 0.5A/ point.
Response time: 1ms.
Common way: 16 point / public end.
Protection function (overload, overheat).
External wiring connection mode: 18 point screw terminal NZ2MC-2MBS.
Output module with mechanical relay contact mechanism,
Including the load voltage range of the relay and can be used for the output of the DC12~24V load transistor output type NZ2MC-2MBS
According to the load voltage, the output points of different, choose the most suitable user needs of the module.
Preventive maintenance based on the life of relay contact.
Relay output module can accumulate the number of ON of each output point NZ2MC-2MBS.
Through the understanding of the relay contacts of the number of times, according to the relay life of preventive maintenance. Axis of control: 8.
Operation cycle: 0.444ms, 0.888ms, 1.777ms, 3.555ms.
Control unit: mm, inch, degree, pulse.
Location data: 600 data / axis.
Boot time (operation cycle 0.444ms, 1 axes): 0.7ms.
Servo amplifier connection mode: SSCNET III /H NZ2MC-2MBS.
Inter station distance (max): 100m.
External wiring connection: 40 pin connector two.
Straight line interpolation: 2 axis, 3 axis, 4 axis.
Arc interpolation: 2 axes.
And the positioning module is the same, simple movement module can be set up simple parameters and through the control program to start,
Easy positioning control, advanced synchronous control, cam control, speed / torque control, and other motion control.
According to the user''s control requirements, from the maximum number of control axis to 2 axis, 4 axis, 8 axis, 16 axis type in the choice of the most suitable module.
Positioning control (sealant / adhesive coating equipment etc.).
Synchronous control / electronic cam control (pick and place machine, packing machine, etc.).
Speed / torque control (stamping machine, die casting machine, etc.).
Speed / position control switching (production of semiconductor chips, etc.).
IQ-R MELSEC series of simple movement module, positioning module, high-speed counter module for intelligent function module,
High speed and high precision motion control, position control and position detection can be carried out by simple programming.
The simple motion module has the same operation convenience as the positioning module,
Like motion controller for synchronous control, cam control and other advanced control.
Can be conneected to the servo system dedicated to support high-speed synchronous network /H III SSCNET servo amplifier NZ2MC-2MBS.
Motion control by simple programming.
Can be realized through the software gear, shaft, transmission, cam action.
The most suitabble for milling spiral line interpolation NZ2MC-2MBS.
Normal start, high speed start, multi axis simultaneous start.
High precision ON/OFF pulse time measurement.


...More relevant models >>>>