Home >> Products >> MITSUBISHI >> Servo driver/Servo motor >> MR-J2 series >> MR-J2 driver (amplifier) >> MR-J2-100A Universal interface driver

MR-J2-100A Universal interface driver

MITSUBISHI MR-J2-100A Manual And Instructions
MR-J2-100A datasheetPDF datasheet
MR-J2-100A Communication Function Operating Installation Guide
MR-J2-100A Absolute Position Detection System Installation Guide
MR-J2-100A Specifications and Installation Guide

MITSUBISHI MR-J2-100A Product information and technical parameters:
Name: Universal interface driver
Model: MR-J2-100A
MITSUBISHI general purpose AC servo amplifier MR-J2 series.
Rated output: 1.0kw.
Interface: general purpose interface.
Voltage: three phase AC200V.
MITSUBISHI servo system in the MITSUBISHI servo amplifier is widely used,
It can not only be used in the high precision position control and speed control of the working machinery and general industrial machinery,
Can also be used in the field of speed control and tension control.
By installing a personal computer with a servo setting software, the parameters setting, trial run, state display, and gain adjustment are performed.
MITSUBISHI servo system MR-J2S column is developed on the basis of the servo MR-J2 series with a higher performance and more features of the MITSUBISHI servo system,
The control modes are position control, speed control and torque control, as well as the switching control mode among them.

Type: HF-SN servo motor, medium inertia power.
Rated output power: 1.0kw.
Rated speed: 2000r/min.
Electromagnetic brake: there.
Oil seal: have.
Encoder resolution: 131072p/r.
S100 representative: Super MR-E special motor.
KH003 special mark for Super MR-E.
High performance and easy to operate, reduce work load MR-J2-100A.
Enhanced system cost performance.
High performance, high precision positioning (servo motor encoder resolution: 131072) MR-J2-100A
High response.
Suppression of vibration by adaptive vibration suppression control.
Using personal computer and servo setup software to optimize tuning.
Has 2 types of interfaces:
Position control and speed control with pulse train interface.
The analog input interface is used for speed control and torque control MR-J2-100A.
Wide use.
Machining equipment and machine tool feed.
Used for food, packaging equipment and feeding device.
For textile machinery, etc..
Can improve the performance of equipment.
Servo amplifier terminals are used to reduce the required wiring time.
The connector is located in front of the servo amplifier, which is convenient for cable connection MR-J2-100A.
The gain adjustment can be easily carried out by the real-time automatic tuning function. MITSUBISHI motor universal AC servo amplifier MELSERVO-J3 series.
Rated output: 0.6kw.
Interface type: SSCNET type III fiber communication.
Power specification: single phase AC200V.
High speed serial communication between the SSCNET and the servo amplifier by using the fastest up to 0.44ms communication cycle,
A fully synchronous control system can be constructed.
It is only necessary to insert the special optical fiber into the joint to form SSCNET III network, which greatly reduces the wiring work and reduces the possibility of false wiring.
Due to the adoption of the optical fiber commuunication, the anti noise ability can be greatly improved and the long distance wiring of 50 meters (maximum 800 meters x 16 axes) can be realized MR-J2-100A.
A servo amplifier to meet the full closed loop control function MR-J3-B-RJ006.
Suitable foor mechanical servo optimization and adjustment!
More advanced optimization adjustment function and control function to maximize mechanical properties MR-J2-100A.

...More relevant models >>>>